Like title says W200, DANA 60's front & rear, 360., factory A/C but it does not work. Cab, floors and mounts have no rust. Located outside of Denver, Colorado.
$11,500 or offer. Add is here with pictures and I can furnish any pictures you might want: 1980 W200 Crew Cab 4X4 - Dodge...
You say you are looking for a long bed, you do mean an full 8'bed correct? If so why are these first two vehicles on your list as they don't have much of a bed at all????
^ ^ ^ ^ ^ ^ So if I check & do not find a vaccum leak, where would a person look next? What is the best way to check for vaccum leaks? I have heard a unlit propane torch/starting fluid/acetylene & so on.
Thanks!
My new to me 1996 5.9 when first started idles about 1050 RPM then drops down to about 850 RPM after say 20 seconds, it does this hot or cold, it sure would be nice to have it idle around 650 or 700 RPM, any suggestions would be appreciated, Thanks!
I had the gas tank out of this truck about 4 years ago, cleaned the crud/water out of it and now it seems to have water in it again. It is a behind the seat tank, a locking gas cap that seems to fit pretty tight to the filler neck. It is only used as a plow truck in the winter & sits 99% of the...
Not yet decided on selling, it's in a Crew Cab that was layed over on it's side and the cab is tweaked a bit. It's a 440 with an auto. in it. I have code violations on my lot. Trying to decide what the truck might be worth. I would kind of like to keep it and I have another cab off another 4x4...
Just a curious question, late 70's DANA 60 front axle with the big locking hubs and discs. What is one in good working order worth these days?
4:10 or 4:11, not sure which ratio it is.
Thank You!
I have a 1980 Crew Cab, the tag on the door says the front axle GAWR is 3,880 #,
call the parts store looking for calipers and they have options for:
3,500 # or 4,500 # front axle. I guess I would use the calipers for a 3,500 # axle?
Thanks!!!
I have a 81 D200 with a DANA 60, the wheel bearing nut is a nylock single nut versus the old two nuts and a lock ring, could someone give me a wheel bearing nut torque spec? I would guess you tighten it to like 150' lb, spin the hub assy., back the nut off then retorque to a very low spec. but...
I was hoping if someone might be able to tell where I could find the wiper motor breaker? The FSM says there is one in the circuit, but, fails to tell you where it is. I can't seem to find it in the fuse panel.
My wipers run for a while then quit then they will come back on.
Thank You in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.