WANTED steering coupler
- Thread starter mopar al
- Start date
- Status
Polara_500
Well-Known Member
What part? Rag joint or cup/coupler or the piece between them?
mopar al
Active Member
N
Need the cup coupler Need the 3" long one
Last edited:
Polara_500
Well-Known Member
Lemme check, got a few but still on the gears.
Polara_500
Well-Known Member
How's about 3-1/8" in length?
mopar al
Active Member
That will be fine
Polara_500
Well-Known Member
Hey Al, You only want the cup part of the coupler? Got one here in one piece with the later "rough country" style boot, came from a p/s 85 D150. Bigger for mailing, but easier to install maybe.
Mike
Mike
mopar al
Active Member
I only need the cup joint. I am going to drill out the spline end to 1" and weld in a Borgeson 11/16x36 spline coupler and install it in my 73 Dart to adapt to the new Borgeson power stearing box.
Polara_500
Well-Known Member
Bear with me here, I think we're talking past each other just a bit - socket only?? No male end whatsoever? (you bystander pervs around can insert whatever jokes you like, btw)
mopar al
Active Member
Socket only. The splined end gets reworked, and the square end gets a rebuild kit and installs on my existing lower shaft.
Polara_500
Well-Known Member
Shoot me an address via PM. Cost ya about postage.
mopar al
Active Member
Address is Al Davis 226 Marne Ave NewKensington Pa 15068
- Status